Skip to content
SuperAlign
Surface
Esc
↑↓navigate↵open⌘Jpreview
On this page

Asset Remediation

Allow, warn, or block an AI asset. What each action does on the endpoint, and how to apply one to one asset, many assets at once, or one asset on one endpoint.

Every AI asset starts Ungoverned: found, scored, but nobody has taken action on it yet. It waits as an asset incident on Incidents › Open. When an Admin or Owner applies Allow, Warn, or Block, the asset becomes Governed and the incident resolves. See Incidents.

The three actions

Action What happens on the endpoint When to use it
Allow Nothing changes. The asset is recorded as approved Assets you are fine with
Warn The person sees a system notification that the asset is not approved, and sees it again each time the asset opens. The asset stays installed Assets under review, or tolerated with a reminder
Block (Beta) We back the asset up, then remove it. If it cannot be removed, we close it every time it opens Assets that are not permitted

An action is company-wide by default. You can also make an exception for one endpoint, for example a security researcher who needs a blocked asset. See One asset on one endpoint.

How an action reaches endpoints

Endpoints that are online act within seconds. Endpoints that are offline act at their next scan. Every endpoint reports back, and failures show in the Audit Log. See On-device enforcement.

Before you begin

You have the Owner or Admin role. Auditors can see the assets but not take action.

Where you take action

Two paths lead to the same controls:

  • Incidents › Open, on the Assets tab — every asset still waiting for a decision, highest risk first.
  • An asset’s panel in Inventory — the Take Action button at the bottom.

An asset stays governed even if no endpoint has reported it recently; actions never quietly disappear.

See Resolve incidents for the step-by-step: take an action on one asset’s incident, apply one action to many selected assets at once (up to 500 per batch, highest risk first, all-or-nothing), or scope an action By Instance to named endpoints. Selecting assets and then changing tabs, filters, search, or sort asks before the selection is discarded.

One asset on one endpoint

To exempt one endpoint, use By Instance when you take the action, or start from the endpoint: on Endpoints, open the endpoint, find the asset on its Assets tab, and use Allow, Warn, or Block (Beta) in its panel — that applies to this endpoint only.

For a Governed asset with no exception on this endpoint, the panel shows Inherits Default under Current Enforcement: the endpoint follows the company-wide action. For an Ungoverned asset, the panel shows Recommended Action instead.

Checking what was applied

Every action, single or batch, is in the Audit Log under Asset Governance, with who applied it, when, and the before and after state of each asset.

Next steps

Was this page helpful?